KT-S Fish Scaler Part
The 150 cm (59") rubber casing for the KT-S Commercial Fish Scaler attaches the motor to the hand-piece and covers the 150cm drive shaft. There is also a 200 cm version.
The Rubber Casing Kit comes with the following pieces when ordered:
1 Rubber Casing (Part 50)
1 Washer (Part 53)
2 Circlips (Part 54) (only one is needed, however they are delicate and two are provided for your convenience)
The KT-S parts diagram can be downloaded here: KT-S parts diagram
Care must be taken when replacing the casing. It is very important to properly attach it correctly to both the hand-piece and the motor. Failure to do so will result in poor operation and cause breaks in the shaft. Please follow the guide in replacing.
MAINTENANCE GUIDE FOR KT-S DRIVE SHAFT AND CASING
When you replace the drive shaft or casing, follow this guide. You can print it out. You can also use the guide to troubleshoot any problems you might have in operation. It is almost always the result of loose connections or a damaged drive shaft or casing.